MULTICOLOR (10) LED SUBMERSIBLE PARTY LIGHT BASE WITH REMOTE CONTROL -BULK PRICE
SKU:
$14.75
$14.75 - $141.00
per item
Each set has 1 Light Base (3 AAA batteries included) and 1 IR
Remote (2 AG10 button cell batteries included).
Light Base The Light Base contains an array of 10 super bright LEDs with 13 colors: red, green, blue, orange, amber, spring green, light turquoise, deep turquoise, sky blue, purple, magenta, pink, and cool white. Dimensions: 2.8 inches diameter, 0.9 inch height, 3.5 oz weight. The Light Base is submersible in liquid to 1 meter (3.28 ft). It is waterproof and wireless, thus perfect for lighting up vases, bowls, or any water filled containers. It can also be used to illuminate flower arrangements, design props, table settings, ice sculptures, and many more.
IR Remote
The IR Remote works in clear line of sight with a range of about 9 meters (30 ft) and it can control multiple Light Bases within range. The IR remote must be aimed at the top of the Light Base.
Buttons
Functions
ON/OFF
Turn light on and off
COLOR SELECTION
Use color buttons to directly select single color mode
FADE/JUMP
Dynamic color changing modes
BRIGHTNESS (5 settings)
Increase or decrease brightness of single color mode
RESET
Reverse to full brightness of single RED color
Instructions
When using the Light Base for the first time, pull out the flat, clear plastic battery shield that sticks out the back of the IR Remote. Open the Light Base by twisting the two halves in the direction indicated on the bottom, remove and unwrap the battery bundle, and install the batteries with the correct polarity. When Light Base batteries run low, not all colors may work, and Light Base may not respond to all buttons on the remote control.
When re-closing the Light Base, it is recommended to tighten the threads to 4 or 5 bumps past where the plastic edge makes contact with the rubber gasket. Over tightening may make it too difficult to open next time, or may damage the gasket or the threads. Under-tightening may result in leaks as the gasket gets less elastic with age and exposure to water and air and temperature changes. It is recommended to tighten the Light Base to the same tightness each time for a good seal.
Safety
- Do not use in beverages.
- Use new alkaline or lithium AAA batteries with 1.5V rating for the light base – do not mix old and new batteries.
- Install batteries with polarity in correct positions as shown in battery compartment.
- Do not expose the IR Remote to direct or indirect moisture.
- Follow battery instructions for proper disposal and cautions.
Light Base The Light Base contains an array of 10 super bright LEDs with 13 colors: red, green, blue, orange, amber, spring green, light turquoise, deep turquoise, sky blue, purple, magenta, pink, and cool white. Dimensions: 2.8 inches diameter, 0.9 inch height, 3.5 oz weight. The Light Base is submersible in liquid to 1 meter (3.28 ft). It is waterproof and wireless, thus perfect for lighting up vases, bowls, or any water filled containers. It can also be used to illuminate flower arrangements, design props, table settings, ice sculptures, and many more.
IR Remote
The IR Remote works in clear line of sight with a range of about 9 meters (30 ft) and it can control multiple Light Bases within range. The IR remote must be aimed at the top of the Light Base.
Buttons
Functions
ON/OFF
Turn light on and off
COLOR SELECTION
Use color buttons to directly select single color mode
FADE/JUMP
Dynamic color changing modes
BRIGHTNESS (5 settings)
Increase or decrease brightness of single color mode
RESET
Reverse to full brightness of single RED color
Instructions
When using the Light Base for the first time, pull out the flat, clear plastic battery shield that sticks out the back of the IR Remote. Open the Light Base by twisting the two halves in the direction indicated on the bottom, remove and unwrap the battery bundle, and install the batteries with the correct polarity. When Light Base batteries run low, not all colors may work, and Light Base may not respond to all buttons on the remote control.
When re-closing the Light Base, it is recommended to tighten the threads to 4 or 5 bumps past where the plastic edge makes contact with the rubber gasket. Over tightening may make it too difficult to open next time, or may damage the gasket or the threads. Under-tightening may result in leaks as the gasket gets less elastic with age and exposure to water and air and temperature changes. It is recommended to tighten the Light Base to the same tightness each time for a good seal.
Safety
- Do not use in beverages.
- Use new alkaline or lithium AAA batteries with 1.5V rating for the light base – do not mix old and new batteries.
- Install batteries with polarity in correct positions as shown in battery compartment.
- Do not expose the IR Remote to direct or indirect moisture.
- Follow battery instructions for proper disposal and cautions.
